Frame:
- Designed in AutoCad
- Made of 1.25 X .049 4130 chromemoly tubing
- Has been tig welded together
- Includes mounts for the suspension, engine/trans, side mirrors,
head lights, fuel tank, body panels, etc.
- Total weight 110 lbs.
- Has side impact protection
- Supports the following engine/transmissions
Body:
- 6130 Aluminum panels
- Access panels are held on by quarter turn fasteners
- Side panels are held on by aluminum rivets
- Roof opens to allow easier access
- Lexan windshield (hardened and UV protected)
- Side markers front & back
- Side mirrors with turn signal indicators
Suspension:
- Designed in AutoCad
- Upper/ Lower A-arms and rear swing arm are made of 4130 chromemoly
- Uses sealed rod ends
- Front suspension is fully adjustable (camber, caster, toe)
- Custom made front spindal
- Rear swing arm allows you to loosen or tighten the drive chain
- Rear swing arm has mounts to hold the brake and emergency
brake calibers
- QA1 adjustable coil over shocks
- Spring rate
- Front 8" X 1 7/8" 110 lbs
- Rear 8" X 1 7/8" 140 lbs
- Weight ?????
(Includes shocks, springs, a-arms, rear swing arm, spindals and rod
ends)
Interior:
- Vapor computer (Speedo, tach, head temp, low oil pressure, turn
signal, neutral indicators, clock, timer, etc.)
- Switches for ignition, head lights, turn signals, horn , starter,
fuel pump, interior lights and fans
- Aluminum shifter
- Emergency brake handle
- Custom made seats(5 lbs per seat)
- Wilwood petal assembly (brake, clutch and throttle)
- Formula steering wheel
- Five point seat belts
Tires:
- Front tires: 120/60 R17
- Rear tire: 180/60 R17
Misc:
- 5 Gallon fuel tank
- AN fittings and hoses are used for brakes, oil, fuel and clutch
- Fiberglass front fenders
- 2 motorcycle saddle bags
- Bicycle rack (holds two bikes)
- Storage behind seats
- Tunable muffler
- K&N air filters
Home
| Products
| Specifications
| Photos
| Contact-Us